行業新聞
  • 您現在的位置:首頁 > 新聞資訊 > 行業新聞 >
  • 萬級無菌實驗室裝修應該注意什麽?
    來源:http://www.relexus.com 瀏覽: 發布日期:2020-11-26
    清理門洞,消除多餘部分。保證門洞兩側都在垂直線上。
    Clean the door opening and remove the excess. Make sure both sides of the door opening are vertical.
    安裝門框上的頂軸部分。
    Install the top shaft part on the door frame.
    用螺絲或者鉚釘組合門框的三根型材。
    Use screws or rivets to assemble the three profiles of the door frame.
    安裝地軸,在地上開出長170mm,寬120mm,深度為55mm的方形坑,澆注砂漿,固定地軸的時候,從頂軸的線垂直至地軸軸承的,固定好地軸,水泥幹燥後進行下一步。
    Install the floor shaft, open a square pit with length of 170mm, width of 120mm and depth of 55mm on the ground, and pour mortar. When fixing the floor shaft, the center line of the top shaft is perpendicular to the center of the bearing of the floor shaft. Fix the floor shaft. After the cement is dried, proceed to the next step.
    無菌室裝修
    安裝門體上軸和下軸。
    Install the upper shaft and lower shaft of the door body.
    安裝門體前,需要注意:鬆開門扇的防盜卡位螺絲;裝門扇前,在地軸上抹上潤滑黃油,以使門扇開合自如增加使用壽命。
    Before installing the door body, attention should be paid to: loosen the anti-theft locking screw of the door leaf; before installing the door leaf, grease the floor shaft to make the door open and close freely and increase the service life.
    調節門扇的前後左右和上下方向:鬆開蓋板可以用扳手調節地軸的螺絲;調節門扇上的下軸,具體方法是調節下軸上的六棱螺絲,順時針調節,門扇向上,逆時針調節,門扇向下。
    Adjust the front, back, left, right and up and down directions of the door leaf: loosen the cover plate and use a wrench to adjust the screw of the floor shaft; adjust the lower axis of the door leaf by adjusting the hexagonal screw on the lower axis clockwise, with the door leaf upward, and the door leaf downward.
    擰緊防盜卡位螺絲。
    Tighten the anti-theft card screw.
    本文由濟南肯德基門窗整理發布,您是不是對這些內容有所了解了呢?更多的內容請點擊:http://www.jnclmcc.com榴莲视频app下载汅api免费會有更多精彩內容等你查看。
    This article is organized and released by KFC doors and windows in Jinan. Do you have any understanding of these contents? For more information, please click: http://www.jnclmcc.com We'll have a lot more to see.